when i try to start the motorcycle all it does is click, when its in gear the back tire wont spin any. I have replaced the release bearing, the side-stand switch and the battery the bike still does nothing. the other day the engine started to start turning but now back to nothing can anyone help me out.|||The click is probably the solenoid, when you installed the battery had you charged it as well as adding the acid? If you did, then you are going to have to track the continuity of wiring to the starter motor 鈥?check the earth 鈥撀爌artially remove the starter motor so that it is disengaged from the starter gear, does it turn easily, does it turn on the ignition?|||The 2 large terminals of the starter solenoid (the battery (+) cable goes
to the solenoid).
Touch both terminals at the same time with a large screw driver (jump the solenoid).
If the starter motor spins, the solenoid is defective - replace the solenoid.
If the starter motor doesn't spin, the problem is battery related.
Charge the battery, clean the terminals and cables with
a wire brush and contact cleaner.
Tighten all fasteners with a wrench - a screw driver won't get them tight enough.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment